Cyclone II On-Chip Termination
Signal integrity is crucial in digital design because system speeds and clock edge rates continue to increase. To improve signal integrity, both single-ended and differential signals should be properly terminated. Termination can be implemented with external termination resistors on a board or with on-chip termination technology. Figure 1 compares the integrity of a signal without termination against one using Cyclone™ II on-chip termination.
Figure 1. Cyclone II On-Chip Termination Improves Signal Integrity
Altera’s Cyclone II devices support both on-chip termination and external termination schemes, as shown in
Table 1.
| Table 1. Termination Solutions Support |
| Termination Type |
On-Chip |
External |
| Series |
Yes |
Yes |
| Parallel |
No |
Yes |
| Differential |
No |
Yes |
On-Chip & Off-Chip Termination Benefits
On-chip termination eliminates the need for external resistors and simplifies the design of a printed circuit board (PCB). The benefits of Cyclone® II on-chip termination are are described in Table 2.
| Table 2. Benefits of Cyclone II On-Chip Termination |
| Benefit |
Description |
| Improved Signal Integrity |
On-chip termination eliminates stub effects and helps to prevent reflections on the transmission line. |
| Simpler Board Design |
On-chip termination minimizes the need for external resistors, allowing designers to use fewer resistors, fewer board traces, and less board space, resulting in a simpler board layout. |
| Lower Cost |
With on-chip termination, fewer resistors, fewer traces, and less space are needed on the board. System designers spend less time in layout. Reducing the designer's layout time and the number of components on the board can result in lower overall system costs. |
| Increased System Reliability |
System reliability increases because on-chip termination reduces the number of components from the PCB. |
Termination with external resistors, on the other hand, provides tighter tolerance and is recommended for designs with stringent impedance tolerance requirements. Figure 2 shows how off-chip termination is implemented using resistor packs.
Figure 2. Off-Chip Termination Using Resistor Packs
Series Termination
Cyclone II devices support on-chip series termination for LVTTL, LVCMOS, SSTL-2 and SSTL-18 single-ended I/O standards (shown in Table 3). On-chip termination is provided at the output signal to match the impedance of the transmission line, which is typically 25Ω or 50Ω. Designers can use this termination in general-purpose applications and to interface with double data rate (DDR) and DDR2 SDRAM memories.
| Table 3. Supported I/O Standards for Series Termination |
| Standard |
Resistance (Ω) |
| 3.3-V LVTTL / LVCMOS |
25 |
| 2.5-V LVTTL / LVCMOS |
50
|
| 1.8-V LVTTL / LVCMOS |
50 |
| 2.5-V SSTL-2 (Class I & II) |
50 |
| 1.8-V SSTL-18 (Class I) |
50 |
Parallel & Differential Termination
Cyclone II devices support parallel and differential termination through external resistors.
Related Links
|
Literature
> 
Next Steps