Supported Device Family:
The SPMI-CTRL core implements a highly featured, easy-to-use controller for the MIPI System Power Management Interface (MIPI-SPMI) bus. It supports the latest version (v2.0) of the MIPI-SPMI specification and is suitable for the implementation of either master or slave nodes in an SPMI bus. The core is designed to minimize the software load on the host processor. Once configured, the core requires no assistance from the host to initialize the bus, connect to bus or disconnect from the bus, grant access of the bus, execute incoming SPMI commands, generate ACK/NACK responses, and check the address and data parity. Although the core only expects the host to provide the outgoing SPMI commands, it provides thorough status information to the host. Integration of the core is extremely simple: The core provides access to its registers via an AMBA™ 2 APB slave interface and converts the incoming SPMI read/write commands to accesses on its AHB master port.
- MIPI-SPMI v2.0 Master or Slave: Supports High Speed (HS) and Low Speed (LS) device classes, all commands and all arbitration levels.
- Low Host Overhead: Host is only required to initialize registers after a reset and define outgoing commands and arbitration levels
- Run-time Debugging: Broadcasts SPMI bus state and device state, detects and reports errors, and can optionally captures all traffic in the SPMI bus
- Easy Integration: Directly bridges SPMI and AHB bus address space, and allows register access via 32-bit AMBA™ 2 APB bus
- Small and Low Power: Around 1,000 ALMs for either a master or a slave core, and direct serial clock usage to minimize switching activity when idle
The SPMI-CTRL core can be mapped to any Intel FPGA Device (provided sufficient silicon resources are available) and optimized to suit the particular project's requirements. When configured as a master the core needs about 1,000 ALMs for its implementation. Approximately 850 ALMs are required for the implementation of slave core. Please contact CAST to discuss resource utilization and performance for your application and target device.
IP Quality Metrics
|Year IP was first released||2016|
|Latest version of Quartus supported||17.0|
|Altera Customer Use|
|IP has been successfully implemented in production with at least one customer||N|
Customer deliverables include the following:
|Any additional customer deliverables provided with IP||-|
|Parameterization GUI allowing end user to configure IP||N|
|IP core is enabled for OpenCore Plus Support||Y|
|Software drivers provided||N|
|Driver OS support||N/A|
|User Interface||Other: AHB and APB|
|IP-XACT Metadata included||N|
|Simulators supported||Modelsim, Questa, NCSIM|
|Hardware validated||Y. Altera Board Name Cyclone IV|
|Industry standard compliance testing performed||N|
|If No, is it planned?||N|
|IP has undergone interoperability testing||N|
|Interoperability reports available||N|
Design Solutions Network Members provide products and/or services that are sold or licensed by the Member and not Altera or its affiliates. Altera and its affiliates hereby disclaim any express or implied warranty of any kind including warranties of merchantability, noninfringement of intellectual property, or fitness for any particular purpose with respect to any such products and/or services.