Article ID: 000075601 Content Type: Troubleshooting Last Reviewed: 06/30/2014

Why don't I see an difference in simulation results when I change the Tx drive strength settings of the IBIS-AMI transceiver models?

Environment

  • Simulation
  • BUILT IN - ARTICLE INTRO SECOND COMPONENT
    Description

    You will not see any difference in drive strength of Altera® Tx IBIS-AMI models if only the Ivod IBIS-AMI parameter is changed. You also need to change the appropriate selected analog IBIS-AMI model. The following document details how to change the Tx drive strength.

    IBIS-AMI Drive Strength Process (Right-click, Save as)

    Related Products

    This article applies to 7 products

    Stratix® V E FPGA
    Stratix® V GS FPGA
    Stratix® V GT FPGA
    Stratix® IV GX FPGA
    Stratix® V GX FPGA
    Stratix® V FPGAs
    Stratix® IV GT FPGA