Active serial (AS) configuration can be performed using an Altera® serial configuration (EPCS) device. During AS configuration, the Altera device is the master and the EPCS device is the slave. Configuration data is transferred to the Altera device on the DATA0 pin. This configuration data is synchronized to the DCLK input. Configuration data is transferred at a rate of one bit per clock cycle. There are two types of AS configuration schemes: AS (20 MHz) and Fast AS (40 MHz).
For more information, please refer to the configuration chapter of the relevant Altera device in the Configuration Handbook.
Configuration Method
- Using a serial configuration (EPCS) device
Embedded Solution
- SRunner (PDF)
- Portable software driver used to program EPCS devices via an AS interface
- Works on a PC using a ByteBlasterTM II download cable
- Source code (ZIP) available for porting to an embedded system or other platform
Application Note
- AN 370: Using the Serial Flash Loader With Quartus II Software (PDF)
- An in-system programmability (ISP) solution used to program EPCS devices via a JTAG interface
User Guide
- Active Serial Memory Interface (ALTASMI_PARALLEL) Megafunction User Guide (PDF)
- This megafunction allows the FPGA to access the memory of an EPCS device through parallel data input and output ports

